1, the two bearings into the rotor-bearing file can be loaded when the hot pack or cold-press method. Regardless of which method to use, force should be added to the bearing inner ring. Heat when the temperature can not be set too high, the general control of the 100 ~ 105 ℃.

2,motor will be loaded after the cover after the bearings, and tighten the screws after the bearing caps.

3,push a back end cover to stator

4, tightening bolts after the cover, put the front cover, the former bearing caps, and screw tightly firmware

5, mounted fans, air cover, and screw tightly firmware.

6, after assembling parts, rotating shaft by hand, if the rotational flexibility without hum, then the end of the assembly

Note: All parts, especially with the surface in the assembly prior to clean-up and rust