Rolling bearing assembly method used should be the size and the amount of interference to choose. General bearing assembly methods are hammering method, using screw or lever presses pressed into France and thermal loading method. But in any case, can not knock the bearing ring, cage, rolling bodies or the sealing member.

    Deep groove ball bearing assembly methods are hammering common law and pressed into law. Small motors are generally used push method, using a direct bearing mounting pressed into the bearing journal and the bearing chamber; while hammering method to use when hammering copper pad in special units, with a hammer onto the bearing inner ring journal or hammering method will load bearing outer ring cap bearing chamber. If a large amount of interference journal size is also larger, in order to facilitate the assembly of hot charging method used, is about bearing heating, and then, and the state of the shaft with the room temperature.